Description
The EZ Drift Active Target hood protects the one spot on a Lowrance ActiveTarget transducer that takes the most abuse: the cable exit. Every time the trolling motor deploys, stows or swings, the wire bends right where it leaves the housing. Over a season that flexing can crack the jacket and break the conductors inside, and this hood is there to stop it.
What this transducer hood is for
EZ Drift built this part for one job. It keeps the wire coming out of the ActiveTarget transducer from flexing and breaking at the transducer. That’s the full description the maker gives, so we won’t dress it up with claims they don’t make.
That one spot matters because the cable and the transducer are a single piece. Lowrance sells the replacement ActiveTarget 2 transducer with its 25 ft cable already attached, so a wire that fails at the housing usually means buying a whole transducer. An EZ Drift Active Target hood is a small part next to that bill.
Fit check before you order
- Made for the Lowrance ActiveTarget transducer, as the product name says.
- The maker’s info doesn’t say whether it’s shaped for the original ActiveTarget, ActiveTarget 2, or both. If you run ActiveTarget 2, email us first and we’ll confirm.
- It guards the cable exit only. It isn’t a mount and doesn’t replace your shaft, forward/down or Scout bracket.
- EZ Drift also makes hoods for the Garmin LVS32 and LVS34, so double-check you’re on the Lowrance version.
If you’re unsure which generation is on your boat, the part number on your module or the original box will settle it. Lowrance’s ActiveTarget 2 page shows the current system for comparison.
Fitting the EZ Drift Active Target hood
Do this with the motor stowed and the transducer where you can reach it without hanging over the bow. Fit the hood over the cable exit, then look at how the wire leaves it. You want a gentle loop past the end of the hood, not a sharp bend.
Next, tie the cable to the shaft so it can’t swing and slap. Leave enough slack up top for the motor to turn all the way in both directions. Deploy and stow a few times and watch the run from the transducer up to the deck. Anywhere the cable pulls tight or gets pinched, fix it in the driveway, not on the water.
The rest of the line is under EZ Drift accessories, including the EZ Drift Transducer Clip. For more on rigging live sonar off the bow, read our forward facing sonar guide.
Questions we get about the EZ Drift Active Target hood
Will it fix a cable that’s already damaged?
No. It’s there to prevent damage at the cable exit, not repair it. If the jacket is already split or the picture cuts out when you wiggle the wire, have the transducer checked before you cover the problem up.
Can I return it if it’s the wrong one?
Yes, as long as it’s unused. It isn’t an electronic item, so unused parts can come back within 30 days. The details are on our returns page.
Do I need one if my cable has never given trouble?
Wear at a cable exit builds slowly and usually doesn’t show until the picture drops out. If your motor goes up and down a lot, a transducer hood takes that strain off early.
Send your boat, trolling motor and ActiveTarget model to sales@trollingmotorsdirect.org and we’ll tell you straight whether this hood suits your rig.









