Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin 010-13350-01 Extension 3 Ft

$84.99

Garmin’s 3 ft LiveScope transducer extension cable, part 010-13350-01. Use it when the transducer cable is a little short of the sonar module, or to add a connection point near the bow.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

A Garmin LiveScope extension cable 3 ft is the fix for a transducer cable that ends just short of where it needs to be. Garmin sells it as the LiveScope Transducer Extension Cable, part number 010-13350-01. Three feet doesn’t sound like much until you’re leaning into the front compartment with a connector that won’t quite reach the sonar module.

When 3 feet is enough

Short extensions earn their keep on re-rigs more than new installs. A few situations where we’d reach for the Garmin LiveScope extension cable 3 ft:

  • Module relocated: you moved the sonar module a foot or two to clear a battery tray or make room in the compartment.
  • New mount: a different trolling motor mount or transducer bracket changed the cable path and ate up your slack.
  • Bow disconnect: some anglers add a short extension near the bow so there’s a connection point close to the motor. That makes it easier to pull the motor or the transducer later without fishing the whole cable back through the boat.
  • Too tight: the stock cable technically reaches, but only stretched tight across the deck. A little slack protects the connector.

Garmin LiveScope extension cable 3 ft at a glance

SpecDetail
Garmin nameLiveScope Transducer Extension Cable
Part number010-13350-01
Length3 ft
Other lengths10 ft (010-12855-00) and 30 ft (010-13350-02)

If your measurement says you’re more than a few feet short, the 10 ft extension is the better buy. One longer cable means one joint instead of two.

Fitting it cleanly

Put the joint where it stays dry and where you can get a hand to it. A spot up under the deck lid or inside the compartment, clipped to the side, beats leaving it on the floor where water collects.

Leave a gentle loop on each side of the connection so a tug on the cable doesn’t load the connector. Secure the run with ties, and keep it clear of the trolling motor power leads where you can. That’s standard practice for keeping interference out of sonar cables.

Check before you buy

Garmin’s 010-13350-01 product page doesn’t publish a compatibility list. If you run a LiveScope setup you aren’t sure about, send us the transducer model first. Electronics and cables are final sale here, as our returns policy explains, so a quick email beats a wrong part.

The rest of our LiveScope cables and parts are in Garmin transducers.

What people ask about the Garmin LiveScope extension cable 3 ft

Can I join two of these together?

You can, but we’d buy the longer size instead. Fewer joints means fewer places for corrosion or a loose connection to cause trouble.

Does it work with the sonar module I already own?

It extends the transducer side of a LiveScope system, the part that plugs into the GLS 10 sonar module. Send us your models and we’ll confirm.

Email sales@trollingmotorsdirect.org (Monday to Friday, 9am to 6pm) with your transducer model and how short the cable falls, and we’ll tell you if 3 feet does it.

Related products

error: Content is protected !!