Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin 70A Power Receptacle for Force Trolling Motors

$49.99

The boat side of Garmin’s 70 amp quick-disconnect for Force trolling motors (010-12832-42). Wire it to the battery bank through a 60 A breaker; the matching Garmin 70A power plug is sold separately.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Wire a Garmin 70A power receptacle into the bow and your Force trolling motor plugs in and out in one move. This is part number 010-12832-42, the half of Garmin’s quick-disconnect that stays in the boat, wired back to your batteries. Plug the motor’s lead in and the Force has power; pull it and it doesn’t.

Where the receptacle goes

Garmin’s Kraken manual puts the plug and receptacle at the bulkhead, and the Force manuals call for a pair rated 60 A or greater. Pick a spot in the bow where the motor’s power cable reaches without strain. Garmin lists that cable at about 4 ft on the 50 inch Force and the Kraken, and 3.5 ft on the 57 inch Force.

Choose somewhere dry that you can reach easily. You’ll plug and unplug it often, and a receptacle tucked behind a hatch frame is one you’ll stop bothering with.

Before you cut or drill for the Garmin 70A power receptacle, check what’s behind the panel: wiring runs, fuel lines and the hull itself. Seal around the mount so water can’t follow the leads down into the bilge.

Wiring the Garmin 70A power receptacle

Extension runGarmin minimumGarmin recommended
0 to 10 ft6 AWG6 AWG
10 to 20 ft6 AWG4 AWG
20 to 30 ft6 AWG2 AWG

Those wire sizes come from Garmin’s Force Pro installation manual. Run the leads from the battery bank through a 60 A breaker to the receptacle, and keep the breaker off while you work. Garmin specifies single-conductor stranded wire with insulation rated 75°C (167°F) or higher, and the manual has extra rules about bundling.

Mark positive and negative at both ends before you crimp anything. Reversed polarity at a receptacle is an easy mistake on a dark garage floor and an expensive one at the motor.

Feeding it the right battery bank

Force motors run on a 24 or 36 V battery bank that can supply 60 A continuously. If you’re picking batteries for a new rig, our lithium trolling motor battery guide is a good starting point.

Questions

Does the Garmin 70A power receptacle come with the plug?

No. The Garmin 70A power plug is a separate listing. You need both halves unless you’re replacing just one.

Do I still need a breaker?

Yes. The receptacle is only a disconnect, so keep a breaker suitable for 60 A continuous between the batteries and the receptacle, as Garmin calls for on Force motors. The Garmin 60A breaker linked above matches that rating.

Can I return the receptacle?

Electronics are final sale at our shop, as set out in our returns policy.

If you’re planning a full rewire, send your motor, boat and battery layout to sales@trollingmotorsdirect.org and we’ll look it over. The rest of the Garmin parts are in our Garmin trolling motor accessories.

Related products

error: Content is protected !!