Description
This deck double monitor mount holds two graphs on one heavy duty mount, with arms you choose in 6, 8, 10, 12 or 14 inch length. It handles depth finders from 7 to 16 inches wide. You also pick a 13 or 15 inch center plate, which sets how far apart the two gimbal plates sit.


Options on the deck double monitor mount
| Option | Choices | What it changes |
|---|---|---|
| Arm length | 6, 8, 10, 12 or 14 inch | Height of the screens |
| Center plate length | 13 or 15 inch | Spacing between the two gimbal plates |
That’s ten combinations. The ruler photo in the gallery shows the height of each set of arms, which is the easiest way to judge them against your deck.
Planning the height
Two graphs on one mount take up more room than one, so height matters in two directions. Too low and you’re looking down past the trolling motor pedal. Too high and the screens block your view of the water ahead.
Stand where you’ll fish, hold a tape measure up from the deck, and compare it with the ruler photo. Then check that the motor clears the mount when it stows.
Choosing the center plate
The 15 inch spreads the units further apart than the 13 inch. Pick it if you run two wide graphs, or if you might upgrade to larger screens later. If you start with the 13 and outgrow it, the 15 inch center plate is sold separately.
Graph fit
On this mount, the depth finder mounts are tapped for Humminbird, Garmin and Lowrance units. The Helix 7 won’t fit without the Helix 7 adapter bracket, sold separately.
Install and add-ons for the deck double monitor mount
- Material: high strength 6061 aircraft aluminum, manufactured and assembled in the USA.
- Tools: standard allen wrenches.
- Deck hardware: not included.
- Plates: mounting plates and under plates are sold separately in our mount plates section.
- Swivel: the Swivel Mount Base Adaptor Assembly lets the whole double mount turn.
Later changes are easy: bolt-on replacement arm sets raise or lower the mount, and a Double to Triple Mount Plate adds a third graph.
Questions
What’s the widest graph the deck double monitor mount holds?
Depth finders up to 16 inches wide, and as narrow as 7 inches.
Can I change arm length later?
Yes. The arm modification sets come in 6 to 14 inch and bolt on in place of your current arms.
Is there a scratch and dent version?
Sometimes. Check the deck double monitor mount scratch and dent listing.
Email sales@trollingmotorsdirect.org with your boat, your trolling motor and both graph models. We’ll help you choose the arm length and plate size before you order, Monday to Friday, 9am to 6pm.













































