Description
A rod leaner gives you a proper place to rest your rod while you retie or take a fish off the hook. Most of us lean the rod against the graph without thinking, and that puts a sideways load on an expensive graph mount every time. This little bracket takes that load instead.
How it attaches
The rod leaner fits on the side of your graph, held by the gimbal knob. You can use the factory knob that came with your unit, or a set of our aluminum graph knobs if your plastic ones have seen better days.
No drilling and no new holes in the console. Loosen the knob, set the bracket in place and snug the knob back down.
Pick the right version
The Monitor dropdown has two choices, because the knob layout differs between units:
- Humminbird Solix, Apex or Xplore: for those three Humminbird lines. See the APEX page on Minn Kota’s site, which now carries Humminbird’s fish finders, if you’re not sure which unit you have.
- Humminbird (not Solix, Apex or Xplore), Garmin or Lowrance: for every other Humminbird, plus Garmin and Lowrance graphs.
Check the model name on the bezel or in the system menu before you choose. Picking the wrong version is the most common mistake with this part.
What it’s made of
The rod leaner is black powder coated aluminum, so there’s no steel to rust and the finish stands up to wet hands and spray. It’s sized for one job: holding a rod off the graph mount while your hands are busy with a knot or a hook.
Because it’s held by the knob, it stays with the graph when you swivel the screen toward the front or back of the boat. There’s no separate base to mount or move.
Why protect the graph mount
A rod leaning on a graph acts like a lever. Wind, a rocking boat or a fish on the line can push hard on the gimbal and the arm below it. Over time that can loosen knobs, wear pivot points or knock a unit out of position. Giving the rod its own rest spot costs a lot less than repairing a graph mount.
Questions we get
Does the rod leaner fit a Humminbird Helix?
Helix isn’t Solix, Apex or Xplore, so you’d choose the second option: Humminbird (not Solix, Apex or Xplore), Garmin or Lowrance.
Do I need new knobs to install it?
No. Your factory knob works. Our graph knobs are an option, not a requirement.
Will it hold the rod while I’m running?
It’s meant for resting a rod while you work on it at a stop, not for storing rods underway. Use a rod holder or a rack for that.
More parts for your screen are in our rod leaner and graph accessories sections. If you’re unsure which version fits, email sales@trollingmotorsdirect.org with your graph model.










