Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Bridge Multi Mount Plates

$60.00

Black powder coated aluminum plates that stiffen an aluminum deck and lessen flex. Any of our bridges mounts to them, in more than one position. Made in the USA.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Bridge multi mount plates stiffen an aluminum deck and lessen the flex that makes a bridge and its screens shake. Any of our bridges will mount to them, and they’re laid out so the bridge can sit in more than one position. They’re black powder coated aluminum, made in the USA.

Why aluminum decks need help

A thin aluminum deck is light and tough, but it bends when you stand near the pedal or when the bow drops off a wave. A bridge bolted to that sheet moves with it, and the screens on top move even more. Over time that deck flex can also loosen hardware.

The bridge multi mount plates go between the deck and the bridge legs and spread the load over a larger, stiffer area. The deck still moves a little, but the bridge has a much better base to sit on.

Multiple mounting positions

The “multi mount” part is about choice. The plates let you mount the bridge in more than one spot, so you can adjust where it sits relative to the pedal or your seat without drilling new holes in the deck each time. If you swap trolling motors or pedals later, that flexibility comes in handy.

Which bridges use the bridge multi mount plates

Any bridge we sell will mount to them. Two of our listings recommend them by name for aluminum decks: the bridge extender rotator and the 12″ span bridge mount. They work just as well under our standard bridges and extenders, all found in the bridge mounts section.

For the stiffest setup, pair them with the Bridge Under Plate below the deck, so the deck is backed from both sides.

Finish and install

The black powder coat is baked on, which holds up better than spray paint to boots and dropped tackle. Use stainless fasteners sized for your deck thickness.

Lay out the bridge multi mount plates and the bridge together with the pedal in place. Step on the pedal through its full travel, check rod and cable clearance, then drill and seal. On salt or brackish water, put a little anti-seize on stainless bolts going into aluminum.

Questions

Do the bridge multi mount plates fit a Bass Cat bridge?

The listing says any of our bridges will mount to them. If you’re running the Bass Cat Lynx bridge, email us first so we can confirm the layout on that boat.

Are they needed on a fiberglass deck?

They’re made for stiffening aluminum decks. Most glass decks are stiffer already, but if yours flexes they can still help.

Questions about your deck? Email sales@trollingmotorsdirect.org with your boat, bridge and pedal and we’ll help. More plates are in our mount plates section.

Related products

error: Content is protected !!