Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin 60A Circuit Breaker for Force Trolling Motors

$89.99

Garmin’s 60 amp circuit breaker for Force trolling motors (010-12832-40). Force motors don’t ship with a breaker, and Garmin’s manuals call for one suitable for 60 A continuous on the power lead.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Every Force trolling motor needs a breaker on its power lead, and the Garmin 60A circuit breaker, part 010-12832-40, is Garmin’s own. Force motors don’t come with one, so this is the matching part for a new install or for replacing a tired breaker. It’s a new unit.

Why a Force needs a 60 amp breaker

Garmin’s Force manuals ask for a 24 or 36 V battery bank that can supply 60 A continuously, plus a breaker rated 42 VDC or greater and suitable for 60 A continuous. The breaker protects the wire between the batteries and the motor if something shorts or the draw climbs past what the circuit can handle.

Garmin does allow a bigger breaker, up to 90 A, when the boat runs hot or the circuit is shared, but only after the wiring has been checked against marine standards. On a typical bass or bay boat with its own trolling motor circuit, 60 A is the number to use.

Wiring the Garmin 60A circuit breaker

  1. Turn the breaker off before you connect the motor’s power cable. Garmin’s manual is clear about that.
  2. Mount it close to the battery positive. Blue Sea’s notes on ABYC overcurrent rules explain how close is close enough.
  3. Size the wire for the run. Garmin lists 6 AWG as the minimum for extensions up to 30 ft, and recommends 4 AWG from 10 to 20 ft and 2 AWG from 20 to 30 ft.
  4. Use single-conductor stranded wire with insulation rated at least 75°C (167°F). Garmin’s tool list includes solder and heat-shrink tubing for extension joints.
  5. Torque or snug every terminal properly and check them again after the first few trips.

The Garmin 60A circuit breaker also gives you a handy shutoff when you’re working on the motor or leaving the boat in storage. Flip it off and the Force is dead until you flip it back.

Other parts on the same power run

If you’d like a quick disconnect at the bow, Garmin also makes a 70A power plug and matching receptacle for Force motors. Garmin’s manuals call for a plug and receptacle rated 60 A or more, so the 70 A pair covers it. For battery choices, our trolling motor battery guide is a good place to start if you’re sizing a 24 or 36 V battery bank.

Breaker questions

Does a new Force trolling motor come with a breaker?

No. Garmin lists the circuit breaker as not included, so plan on buying one with the motor. The full power spec is in the Force owner’s manual.

Will the Garmin 60A circuit breaker work on a Kraken?

Garmin’s Kraken install manual calls for the same 60 A continuous rating. This part is listed for Force motors, so email us with your model and we’ll confirm.

Is the breaker returnable?

Electronics are final sale at our shop, so check the part number against your rig first. Our returns policy has the details.

Email sales@trollingmotorsdirect.org with your motor, battery setup and wire run length if you’d like a second set of eyes on the plan. More Garmin parts are in our Garmin trolling motor accessories.

Related products

error: Content is protected !!