Description
If the stabilizer that came with your Garmin Force trolling motor is lost, cracked or worn through its rubber stops, the Garmin Force stabilizer (part 010-12832-50) is Garmin’s replacement. It supports the motor once it’s stowed, so the head and shaft don’t hammer the mount every time the bow drops off a wave or the trailer finds a pothole.
Why a stowed motor needs support
A stowed trolling motor is a long lever resting on a hinge. Run across a chop or tow down a rough road and that lever bounces. Every bounce loads the mount bolts and the deck under them.
Garmin’s Force Pro installation instructions describe the stabilizer as an optional accessory that gives the motor extra support in the stowed position. The same document says to install one to reduce the risk of damage to the mount, and to the boat, when you drive in rough conditions or trailer. That’s the whole job of a trolling motor stabilizer, and the Garmin Force stabilizer is Garmin’s own part for it.
Garmin Force stabilizer part details
| Item | Detail |
|---|---|
| Part number | 010-12832-50 |
| Listed for | Garmin Force trolling motors |
| Replaces | The stabilizer included with the Force |
| Weight | 0.54 kg (1.2 lb), per Garmin’s manuals |
| Instructions | Packed in the stabilizer box, per Garmin |
| Not for | Force Kraken, which uses its own deck mount stabilizer |
Our listing names this part for Force motors, and it’s the direct replacement for the one that shipped with the original Force. Garmin’s Force and Force Pro manuals both give the same 1.2 lb stabilizer weight, but neither prints a part number. If you run a Force Pro, email us your motor model before ordering and we’ll confirm the match.
The Force Kraken is a different setup. It takes the Garmin deck mount stabilizer for Kraken motors, and the Kraken manual has you clamp the shaft in it after you stow. Other Garmin spares, from props to nose cones, are in our Garmin trolling motor accessories.
Care and checks
Garmin’s maintenance list for the Force says to check the rubber stops on the ends of the stabilizer for wear and replace them as needed. Once the rubber is gone, the motor rests on hard parts instead of a cushion.
- Every trip: clamp the motor in the stabilizer whenever it’s in the stowed position, not only before a long tow.
- Every season: look over the rubber stops and the deck hardware.
- Loose bolts: trailer vibration works hardware loose. A medium-strength threadlocker such as Blue Loctite is the usual fix for bolts that keep backing out.
Stabilizer questions
Does the Garmin Force stabilizer fit a Force Kraken?
No. The Kraken has its own deck mount stabilizer (010-12832-55). Check your motor model before ordering either one.
Is it worth fitting if I only fish calm lakes?
Garmin calls it optional. Rough water and trailering are when it earns its place, and most boats see one or both. On a boat that lives on a trailer, we’d run one.
Can I send it back if I order the wrong one?
It’s listed with our electronics, and electronics are final sale under our returns policy. That’s why we’d rather check fit with you first.
Email sales@trollingmotorsdirect.org with your boat, your Garmin motor model and its shaft length, and we’ll tell you which stabilizer fits before you buy.









