Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Lowrance In-Hull Transducer 9-Pin 83/200kHz

$106.00

Depth-only Lowrance skimmer at 83/200 kHz with a 9-pin plug. Install it shoot-thru inside a solid fiberglass hull or on a trolling motor. No temperature sensor. Model 000-14886-001.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

You can install the Lowrance 9-pin in-hull transducer 83/200 two ways: bonded inside a solid fiberglass hull to shoot through it, or mounted on a trolling motor. It’s a depth-only skimmer that runs 83 and 200 kHz and plugs into a 9-pin sonar port. Lowrance’s model number is 000-14886-001.

There’s no temperature sensor on this one. If you want water temp on screen, the version with a remote temp sensor is the one to buy.

Shoot-thru or trolling motor

  • Shoot-thru the hull: nothing hangs off the transom, so there’s no bracket to snag weeds, get knocked on the trailer or kick up spray at speed. The trade-off is some signal loss through the fiberglass.
  • On the trolling motor: the sonar sits right where you’re fishing at the bow, which helps when you’re working a weed edge or a dock line.

Shoot-thru installs only work on solid fiberglass. Cored hulls with foam or balsa between the skins, and aluminum hulls, block too much of the signal. If your boat is one of those, mount the Lowrance 9-pin in-hull transducer 83/200 on the trolling motor instead. Sound passes well through solid laminate but poorly through air and foam, as the fishfinder article on Wikipedia explains in its section on how sonar works.

Even on a good solid hull, a shoot-thru install gives up a little depth range and sensitivity compared with the same transducer in open water. For most inland fishing that’s an easy trade for a clean transom and nothing to break off on the trailer.

Finding a good spot inside the hull

Test before you bond. With the boat in the water, set the transducer face down in a little water at the spot you’re considering and watch the depth reading at idle and at speed. If the bottom drops out, try somewhere else. Then bond it following Lowrance’s instructions, working out any air bubbles, since trapped air weakens the signal.

Specs at a glance

ItemDetail
Frequencies83/200 kHz
ReadingsDepth only
StyleSkimmer
InstallShoot-thru hull or trolling motor
Plug9-pin

Need more reach to the console? The XT-10BLK adds 10 ft to a 9-pin transducer. Lowrance says to use no more than one extension per install.

Lowrance 9-pin in-hull transducer 83/200 questions

Does it show DownScan?

No. It’s 83/200 kHz sonar only, which is fine for depth, bottom and fish arches.

Can I move it from the hull to the motor later?

Once it’s bonded in, plan on it staying there. Decide on the location before you mix the adhesive.

Can I return it?

No. Transducers are electronics and are final sale (see returns).

Email sales@trollingmotorsdirect.org with your hull type and display, and we’ll confirm the Lowrance 9-pin in-hull transducer 83/200 suits it. Other options are in Lowrance transducers.

Related products

error: Content is protected !!