Description
Every NMEA 2000 backbone needs two end plugs, and the Lowrance TR-120-KIT terminators are exactly that: one male and one female 120 ohm terminator. Without them the network can’t hold a clean signal, and devices drop off, flicker in and out, or don’t show up at all.
Why a backbone needs exactly two
Data on an NMEA 2000 backbone travels as a signal along the cable. At an open end, that signal bounces back and garbles the next message. A terminator at each end absorbs it. The standard calls for a single 120 ohm terminator at each end of the bus, per the NMEA 2000 summary on Wikipedia, so it’s always two: not one, not three.
Terminators plug into the open backbone port on the last tee at each end. Put those end tees where you can reach them, because they’re the first thing to check when the network misbehaves.
Why one male and one female
A backbone built from tees and cables usually ends in opposite connector genders, a male at one end and a female at the other. The kit gives you one of each so both ends are covered without guessing. The same pair (TR-120M-RD and TR-120F-RD) comes in the N2K-EXP-RD-2 starter kit.
Checking termination with a meter
This is the quickest check on a network that’s acting up. With the network powered off, measure resistance across the two data lines at any tee:
- About 60 ohms: correct. Two 120 ohm terminators in parallel read 60.
- About 120 ohms: one terminator is missing or not seated.
- About 40 ohms: there’s an extra terminator somewhere, often one left in the middle after the backbone was extended.
A reading nowhere near these numbers can also mean a damaged cable or a wet connector, so check those before you replace parts.
Common termination mistakes
- A terminator left behind mid-backbone after someone added a cable and a new end.
- A terminator unplugged to add a device and never put back.
- A corroded terminator in a wet spot. If yours looks green inside, replace the pair.
Lowrance TR-120-KIT terminators questions
Will the Lowrance TR-120-KIT terminators fit my red Lowrance network?
Yes. They’re red-network parts, the same family as the N2K-T-RD tee and the N2KEXT cables.
Do I need new ones when I extend my backbone?
Not usually. Move the existing terminator to the new end. Buy the Lowrance TR-120-KIT terminators if one went missing or got wet.
Are they final sale?
Yes. They’re electronics parts (see returns).
Network acting strange? Email sales@trollingmotorsdirect.org with what’s on it and what you’re seeing, and we’ll help you track it down. Other network parts are in Lowrance graph accessories.









