Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Knob Tool

$25.00

A small tool that fits the knobs with holes on our Console Track Plate Mount and Console Track Shelf Mount, so you can tighten them a little more than by hand. Anodized aluminum, stainless hardware.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Some of our console mount knobs have holes in them, and the knob tool fits those holes so you can get the knobs a bit more snug than your fingers can. It’s made for the Console Track Plate Mount and the Console Track Shelf Mount. It’s a small part, but it’s the difference between hand-tight and properly tight.

Which knobs the knob tool fits

It’s made for use with some of our knobs, specifically the ones with holes in them on these mounts:

It isn’t a universal knob wrench. If you have a different mount or a knob without holes, email us before ordering and we’ll tell you if it helps.

Why a little more snug matters

A console mount takes a beating. Every wave you run through shakes the graph, and a knob that’s only finger-tight can let the screen tip forward or creep off the angle you set. A knob tool gives you more grip on the knob, so you can tighten it a touch further and keep the graph where you put it.

Don’t overdo it. A little past hand-tight is plenty. Cranking on aluminum parts as hard as you can is how threads get damaged.

Using the knob tool

  1. Set the graph at the angle you want and tighten the knob by hand.
  2. Fit the knob tool into the holes in the knob.
  3. Turn it a little further, just until it feels firm.
  4. Check the angle again. If the graph moved while you tightened, loosen, reset and repeat.

To loosen, do the same in reverse. A knob that was snugged with the knob tool may need the tool to break it free again, which is one more reason to keep it on board.

Build

ItemDetail
MaterialAnodized aluminum (here’s how anodizing protects it)
HardwareStainless
Works withKnobs with holes on our console track mounts
Made inThe USA

Keep it on the boat

The knob tool is small enough to live in the console glove box or a tackle tray. Graph angles get changed on the water, not in the garage, so it’s most useful when it’s within reach. Our full console track mount range is in one place if you’re still choosing a mount.

Questions

Does the knob tool fit the graph’s own gimbal knobs?

It’s listed for the knobs with holes on our Console Track Plate Mount and Console Track Shelf Mount. For other knobs, ask us first.

Do I need it?

Not to install the mount. It’s for getting the knobs a little tighter than by hand.

Can I return it?

Unused, non-electronic parts like this one have a 30-day return window. See our returns page.

Questions about your console track setup: email sales@trollingmotorsdirect.org, Monday to Friday, 9am to 6pm.

Related products

error: Content is protected !!