Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Bridge Offset Plate Forward and Aft

$59.00

A 1/2″ black anodized aluminum plate that moves a single or double mount forward or aft off the bridge. Fits our console, deck, double and folding mounts; telescoping swivel with an adaptor plate.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Sometimes a graph sits right side to side but too close or too far from you, and the forward and aft bridge offset plate fixes that by moving your mount, single or double, forward or aft off the bridge. It’s a 1/2″ aluminum plate, black anodized. The offset also helps when the screen sits right where the trolling motor cables run.

Why shift a mount fore or aft

A bridge puts the mount directly over the pedal. Sometimes that’s not the best spot. You might want the screen pulled back toward you so you can read it while standing on the pedal, or pushed forward so the arms and gimbal clear your knees, rod butts or the trolling motor’s cables.

The forward and aft bridge offset plate bolts to the bridge and the mount bolts to the plate, putting the mount forward or behind the bridge line depending on which way you turn it.

What fits the forward and aft bridge offset plate

  • Single console mount, such as our console single mount
  • Single deck mount
  • Double mount
  • Single or double folding mount
  • Telescoping swivel mount, single or double, with an add-on plate (below)

Telescoping swivel mounts need the Telescoping Swivel Mount/Bridge Adaptor Deck Plate, sold separately, before they’ll go on the offset plate.

Build

The plate is 1/2″ thick aluminum with a black anodized finish. Anodizing turns the outer layer of the aluminum itself into a hard oxide, so there’s no paint to peel off where boots and rods knock it.

Fitting tips

Bolt the offset plate to your bridge and set the mount on it loosely first. Sit and stand where you normally fish and check the screen distance both ways. Once you like the position, tighten everything with the mount’s normal hardware.

If you can’t decide, fish a day with the forward and aft bridge offset plate set one way. Screen distance is easier to judge on the water than in the driveway, and turning it around later only takes a few bolts.

A forward offset puts more weight out over the edge of the bridge, so check that the bridge itself is solidly bolted down. On aluminum decks, a Bridge Under Plate helps. Other plates and adaptors are in our mount plates section.

Questions

Can the forward and aft bridge offset plate go both directions?

Yes. It moves the mount forward or aft off the bridge, so you pick the direction when you install it.

Does it fit a telescoping deck mount?

The listing covers telescoping swivel mounts with the adaptor plate. For a different telescoping mount, email us before ordering.

What if the offset turns out wrong for my boat?

If it’s unused, it can come back within 30 days. Our returns policy has the details.

Email sales@trollingmotorsdirect.org with your bridge, mount and boat, and we’ll confirm the forward and aft bridge offset plate fits your setup.

Related products

error: Content is protected !!