Description
If your console sits at an awkward angle, the console single graph mount gives you three places to fix it. The base knuckle rotates 360 degrees and locks into several indents, the top plate turns 30 degrees either way, and the arms have several adjustment points of their own. You pick an arm length from 4″ to 12″, and every version is 6061 aircraft aluminum with stainless steel screws, manufactured and assembled in the USA.
Three places to adjust
Base knuckle. The base plate knuckle rotates a full 360 degrees with several indents to lock it in place, so the mount can point anywhere from the spot you bolt it.
Arms. The arms have several adjustment points, which is how you set the height and reach of the graph above the console.
Top plate. The top plate rotates 30 degrees in either direction. That’s your fine adjustment for glare or for turning the screen toward a passenger.
Set them in that order: knuckle first to point the console single graph mount the right way, then the arms for height and reach, and the top plate last for the final angle.
Choosing an arm length
| Arm length | Good for |
|---|---|
| 4″ | Low profile, under a windshield |
| 6″ | Most small consoles |
| 8″ | Lifting the screen above gauges |
| 10″ | Clearing a wheel or switch panel |
| 12″ | Most reach, for tall consoles or standing drivers |
Measure from where the base will bolt to where you want the middle of the screen, and pick the arm length that gets you there with a little room to adjust.


Graph fit and add-ons
The top plate is tapped for multiple depth finders. It won’t fit the Humminbird HELIX 7 as is; that unit needs the Helix 7 adapter bracket, sold separately.
Two add-ons are worth knowing about. The CA Base hides the wire hole under the mount for a cleaner install. The Swivel Mount Base Adaptor Assembly lets the whole console single graph mount swivel. Both are sold separately.
Installing
Console mounting hardware isn’t included, so pick stainless bolts that suit your console’s thickness, with washers or a backing plate inside. Adjustments use standard Allen wrenches. Set the knuckle, arms and top plate with the graph on and you sitting at the helm, then tighten everything firmly.
If you’re adding the CA Base, fit it under the base before the mount is bolted down, and feed the cables through first. Leave enough slack that the top plate can swing its full 30 degrees each way without pulling on a connector.
Questions
Can the console single graph mount go on a deck?
It’s designed as a console mount. For the bow, look at our deck single monitor mount.
Is a scratch and dent version available?
We list one separately with cosmetic flaws, sold as is.
See more in our console mounts section, or email sales@trollingmotorsdirect.org with your console, graph and boat for help choosing an arm length.








































