Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

8 Pole Launch Pad

$144.00

Holds eight rods upright where you can grab them fast. Order it to screw down to the floor, or with a pin for a 3/4 inch or Ranger 1.77 pedestal hole. Deck mounting hardware is not included.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

If you carry a deck full of rods, the 8 pole launch pad gives eight of them a place to stand upright within arm’s reach. Pull up on a spot, grab the rod you want and fish. It’s the bigger brother of our 4 pole pad, and it adds the option of mounting in a seat pedestal hole instead of screwing it to the floor.

Three ways to mount the 8 pole launch pad

The Pin Size dropdown decides how the pad attaches to your boat. All three options cost the same, so pick the one that matches your deck.

  • Floor mount, no pin needed: the pad screws straight down to the deck. You supply the screws or bolts.
  • Pedestal hole size 3/4: comes with a pin for a 3/4 inch pedestal hole.
  • Ranger pin size 1.77: comes with a pin sized for the 1.77 inch Ranger pedestal hole.

A pedestal hole you aren’t using for a seat is a handy home for it. No new holes in the carpet, and you can pull the pad out when you want the space back.

Sizing up the right pin

Measure the inside of the hole before you order the 8 pole launch pad. A 3/4 inch hole and a 1.77 inch Ranger hole are far apart, so a quick check with a tape or calipers settles it. If your boat has a threaded socket or a size not listed here, email us before ordering.

If you go with the floor mount, deck mounting hardware isn’t included. Use stainless fasteners and check what’s under the carpet before you drill.

8 Pole Launch Pad dimensions and build

ItemDetail
Capacity8 rods, held vertically
Size11 1/2 in L x 5 3/4 in W x 7 1/4 in H
BodyCNC machined Sea Board plastic
Spacers6061 aluminum
HardwareAll stainless steel
Deck mounting hardwareNot included

On the 8 pole launch pad, machined plastic plates with aluminum spacers and stainless hardware mean there’s nothing to rust where the rods sit. Rinse it with fresh water now and then if you fish around salt.

Questions

Is the 8 pole launch pad the same height as the 4 pole?

Yes. Both are 11 1/2 inches long and 7 1/4 inches tall. The 8 pole is 5 3/4 inches wide against 2 3/4 inches for the 4 Pole Launch Pad.

Can I move it between the floor and a pedestal hole later?

The listing sells it with one pin choice. If you think you’ll want both setups, tell us when you order and we’ll check what’s possible.

Does the pedestal hole version need any drilling?

Not if the hole is already there. The pin drops into the existing pedestal hole.

See the full range of launch pad rod holders, or email sales@trollingmotorsdirect.org with your boat model and the pedestal hole size, and we’ll tell you which pin to pick.

Additional information

Pin Size

Floor mount No Pin Needed, pedestal hole size 3/4, Ranger pin size 1.77

Related products

error: Content is protected !!