Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Telescoping Mount Single to Double Plate

$123.00

Telescoping single to double plate for our single telescoping mounts. Swap the single gimbal plate for a double setup with a 13″ or 15″ center plate. Plates tapped 1/4-20. Helix 7 needs an adapter.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

With the telescoping single to double plate, one of our single telescoping mounts can carry two graphs. Take off the single gimbal plate, put the double setup in its place, and you’re done. It’s a simple job.

How the swap works

  1. Remove the graph and its bracket from the mount.
  2. Take off the single gimbal plate.
  3. Fit the double gimbal plate setup.
  4. Mount both graphs and tighten everything down.

Nothing about the telescoping tube or the base changes, so your height adjustment works exactly as before.

Two graphs weigh more than one. Once both are on, run the mount up and down a couple of times and recheck the tightness at the top.

Center plate length: 13 or 15 inch

The center plate sets how far apart your two graphs sit. The 13-inch plate keeps the pair tighter. The 15-inch plate spreads them further, giving bigger screens more room. Choose from the lengths shown in the drop-down when you order.

The gallery has photos of both the 13-inch and the 15-inch plates, which helps you picture the spacing on your own deck.

If you run two large units, the longer center plate is the safer pick. If deck space is tight, the shorter one keeps things compact. Not sure? Send us both graph models.

Graph fit and threads

The gimbal plates are tapped for 1/4-20 threads, the common Unified coarse thread you’ll find at any hardware store. Replacement bolts are easy to come by if one goes overboard. Buy stainless if you replace one, since plain steel rusts and stains the finish.

The gimbal plates take all graphs except the Helix 7. For a Helix 7, add the Helix 7 adapter bracket, sold separately.

To go back from two screens to one later, our single monitor mount plate converts a double to a single. See all our mount plates for the other layouts.

Before you order

  • Confirm your mount is one of our single telescoping mounts.
  • Check clearance at full height and full swivel, with two screens in place, against the windshield, console and seats.
  • Plan the second graph’s power and transducer cables. The telescoping single to double plate holds the screen, but the wiring is a separate job.

Questions

Which mounts take the telescoping single to double plate?

It’s made for our single telescoping mounts.

What thread do the gimbal plates use?

1/4-20.

Will a telescoping single to double plate hold a Helix 7?

Yes, once you add the Helix 7 adapter bracket.

Can I go back to a single screen later?

Yes. Keep the single gimbal plate in a drawer. Swapping back is the same job in reverse.

Email sales@trollingmotorsdirect.org with your mount and both graph models if you’d like a second opinion on the center plate length.

Additional information

Center Plate Length

13", 15"

Related products

error: Content is protected !!