Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Under Plate For Monitor Mounts

$46.00

Monitor mount under plate: a 1/4″ aluminum plate that goes under the deck to secure your mount base. Includes three 5/16 stainless bolts, 2″ long, with stainless nylock nuts. Does not fit the telescoping base.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The monitor mount under plate is a 1/4-inch aluminum plate that goes under the deck, so your mount base bolts through into something solid instead of just the deck skin. The deck ends up sandwiched between the base on top and the plate below.

Why use an under plate

A graph on a mount acts like a lever. Every wave, every time someone grabs the screen to steady themselves, that load goes into the few square inches under the mount base. On a thin or aluminum deck, that’s how you get flex, loose bolts and eventually cracks.

An under plate spreads the load over a wider area and gives the nuts something flat and stiff to pull against. It’s a cheap part that keeps an expensive screen steady.

What’s in the package

PartDetail
PlateAluminum, 1/4″ thick
BoltsThree 5/16 stainless steel, 2″ long
Nuts5/16 stainless steel nylock nuts
FitsOur standard mount base
Does not fitTelescoping base

Nylock nuts have a nylon ring inside that grips the bolt thread, so they resist backing off from vibration. Use a fresh one if you ever take the mount off and refit it, since the nylon grips best the first time.

Check your deck thickness first

The bolts are 2 inches long. They have to pass through the mount base, the deck and the 1/4-inch plate and still leave enough thread for the nylock nuts to grab fully. A thick deck with carpet on top can use that up quickly. Measure before you drill, and if it’s tight, pick up longer 5/16 stainless bolts.

Run a bead of marine sealant around each bolt hole on the deck surface before the base goes down, so water can’t wick into the deck along the bolts.

Getting under the deck is usually the hard part. Pull a hatch or access panel, and have a helper hold the monitor mount under plate while you start the nuts from below.

Which mounts it fits

The monitor mount under plate fits our standard mount base, the base on mounts like the Deck Single Monitor Mount. It does not fit the telescoping base. For MEGA bases, the swivel base and other mounts, see the Universal Under Plate, and for bridges, the Bridge Under Plate.

Questions

Does the monitor mount under plate fit a telescoping mount?

No. It fits our standard mount base only.

Is hardware included?

Yes. Three 5/16 stainless bolts, 2 inches long, and stainless nylock nuts.

Is the monitor mount under plate worth it on an aluminum boat?

That’s where it matters most. Thin aluminum deck sheet flexes far more than a cored fiberglass deck.

Browse all our mount plates, or email sales@trollingmotorsdirect.org with your boat and mount if you’re not sure which under plate you need.

Related products

error: Content is protected !!