Description
The MEGA 360 stabilizer bracket for Ultrex braces a Humminbird MEGA 360 that’s already mounted on a Minn Kota Ultrex with the 360 bracket. It keeps the 360 from shaking while you’re trailering or running through rough water, which is when transducers and shafts get hurt. It doesn’t fit the Ultrex Quest.
What the bracket is protecting
A MEGA 360 hangs off the motor on its own shaft. Every pothole between your driveway and the ramp makes that assembly bounce, and so does every wave you hit on a windy run back to the dock. Over a season, that movement works on the transducer housing and puts stress on the 360 shaft.
The stabilizer ties the 360 in so it rides with the motor instead of swinging beside it. Next to the cost of a new 360 transducer, the MEGA 360 stabilizer bracket for Ultrex is an easy add for anyone who tows a lot of miles.
Fit check for the MEGA 360 stabilizer bracket for Ultrex
- Fits: Minn Kota Ultrex trolling motors with the 360 bracket installed.
- Does not fit: the Ultrex Quest. If your manual or the motor’s label says Quest, this isn’t your part.
- Not included: the MEGA 360, the motor and the 360 bracket.
If there’s no 360 bracket on the Ultrex yet, start with the MEGA 360 Ultrex mounting hardware kit, our complete port side setup, and add the stabilizer after. If you run a different 360 bracket, send us a photo and we’ll tell you whether the stabilizer lines up with it.
Getting it ready for the road
The product photos show where the bracket sits against the 360 and the motor, so study them before you start. Once it’s on, deploy and stow the Ultrex a few times at the dock and make sure nothing rubs, pinches the 360 cable or stops the motor from locking down.
Road vibration loosens bolts on any bow setup. Check the hardware on the 360 bracket and the stabilizer after your first couple of tows. If a bolt keeps backing out, a drop of Blue Loctite threadlocker usually settles it.
If you’re new to the 360 itself, the 360 Imaging section of Minn Kota’s Humminbird Imaging page explains what it shows. Our clamps, tubes and brackets for it are under MEGA 360 mounts.
Questions
Will the MEGA 360 stabilizer bracket for Ultrex work on an Ultrex Quest?
No. It’s built for the original Ultrex with the 360 bracket. Quest owners should look at our MEGA 360 Ultrex Quest mounting hardware.
I mostly fish calm lakes. Do I need one?
If you trailer, probably. Highway miles shake a 360 far more than a flat day on the water does, so the bracket earns its place even without big waves.
Can I return it?
Yes, if it’s unused and within 30 days. The details are on our returns page.
If you’re unsure which Ultrex or bracket you have, email sales@trollingmotorsdirect.org with your motor model and a photo of the 360 setup, and we’ll confirm the fit before you order.










