Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Bridge Starboard or Port Offset

Price range: $172.50 through $195.50

An offset bridge that puts your double, single, telescoping or folding mount on the port or starboard side. Bolted 6061 aluminum, black powder coat, rotating six-hole top. Choose 5″ to 8″ legs.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Trolling motor cables catching the corner of a screen is a common annoyance, and the port or starboard offset bridge fixes it by moving your graph mount off to one side instead of dead center over the pedal. On boats with a recessed foot pedal, it also keeps a folding mount’s kickstand from resting on the pedal. The top rotates, so one bridge covers either side.

Two problems it fixes

Cables catching screens. The pedal area is where trolling motor cables live. On a cable-steer motor, the pedal is tied to the motor itself, as Minn Kota’s buying guide describes. A monitor centered over that area puts its corners right where cables move. Shift the mount sideways and the corners are clear.

Kickstand on the pedal. A folding mount has a kickstand. If your pedal sits in a recessed tray, a centered folding mount can end up with the kickstand landing on the pedal itself. With the mount offset, the kickstand comes down on deck instead. Our kickstand rest is worth a look for the same setup.

Choosing port or starboard

The bridge top has six holes and can be rotated, which is what makes this a port side or starboard side mount. Pick the side away from where your cables run, then think about where you stand and which way you look when you fish the bow. If you change your mind later, unbolt the top and turn it around.

Port or starboard offset bridge specs

  • Takes double, single, telescoping and folding mounts
  • Heavy duty 6061 aircraft aluminum with black powder coat
  • Bolted together, not bent from one piece
  • Stainless steel hardware
  • Six-hole top that rotates for port or starboard
  • Leg height: 5″ (standard), 6″, 7″ or 8″
  • Deck mounting hardware not included

The ruler photos show the standard 5″ legs. If you order 7″ legs, add 2″ to the total heights in those pictures; adjust the same way for 6″ or 8″.

Installing it

Put the pedal where it’ll live, set the port or starboard offset bridge over it with your mount loosely attached, and stow and deploy the trolling motor a few times. Watch the cables and the corners of the screen. When nothing touches, mark the legs, check under the deck, then drill and seal.

Deck hardware is up to you. On aluminum decks, the Bridge Under Plate goes below the deck to cut flex, and it fits this bridge.

Questions

Can I switch the port or starboard offset bridge to the other side later?

Yes. The top rotates, so the same bridge can be set up for either side.

Will my folding mount work on it?

Yes. Folding mounts like our folding single monitor mount are one of the main reasons this bridge exists.

Why bolted instead of bent?

The bolted design is what lets the top come off and rotate between port and starboard.

For other layouts, browse the bridge mounts category. Email sales@trollingmotorsdirect.org with your boat, pedal and mount, and we’ll help you pick the side and legs.

Additional information

Leg Height

5" (Standard), 6", 7", 8"

Related products

error: Content is protected !!