Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Telescoping Swivel Mount Bridge Adaptor/Deck Plate

$51.00

Telescoping swivel bridge adaptor plate: a 4″ x 4″, 1/2″ black anodized plate that mounts our Telescoping Swivel and Short Swivel to a bridge, or stays on deck when the mount comes off. Stainless bolts included.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The telescoping swivel bridge adaptor plate does two jobs. It lets a Telescoping Swivel or Telescoping Short Swivel mount sit on one of our bridges, and it works as a deck plate that stays behind when you take the mount off.

Job one: mounting to a bridge

The swivel base doesn’t bolt straight to our bridges. The telescoping swivel bridge adaptor plate goes between them. It’s threaded to hold the Telescoping Swivel base, so the mount sits on the bridge right over your trolling motor pedal.

Several of our other parts call for it when they go on a bridge, including the swivel mount base adaptor assembly and the telescoping swivel conversion kit. If you’re building a bridge setup from separate parts, this is usually the piece people forget.

Job two: a deck plate

Fasten the telescoping swivel bridge adaptor plate to the deck and mount the swivel base to it. When the mount comes off, all that’s left is a 1/2-inch plate, 4 inches square. That’s handy if you trailer, store the boat under a cover, or move the mount between boats with a plate on each.

A low, flat deck plate is also much easier on bare feet and fly line than a full base left sticking up.

To install it on a deck, set the plate where the mount will live and sit the mount on it with the graph attached. Check the swivel and screen clearance, then mark and drill. Bed each hole in marine sealant and fit the swivel base with the included stainless bolts.

Specs

SpecDetail
Size4″ x 4″ square
Thickness1/2″
FinishBlack anodize
FitsTelescoping Swivel and Telescoping Short Swivel mounts
Threaded forThe Telescoping Swivel base
IncludedStainless steel bolts to mount the swivel base to the plate
ToolsStandard Allen wrenches
Telescoping swivel bridge adaptor plate from above

A standard Allen key set covers the base-to-plate bolts. Fasteners for the deck aren’t listed, so have stainless hardware ready for that side of the job.

A cosmetic second of a similar plate, which also takes the Over the Side Mount base, is listed as the bridge adaptor deck plate scratch and dent. It’s sold as is, final sale.

Questions

Does the telescoping swivel bridge adaptor plate fit the short swivel?

Yes. It works with both the Telescoping Swivel and the Telescoping Short Swivel.

Are bolts included?

Yes, stainless steel bolts for fixing the swivel base to the plate.

Do I need it if I buy a bridge combo?

No. Our bridge combo kits already include the bridge adaptor plate, so you’d only need this one for a second bridge or as a deck plate.

See our other mount plates or the Bridge Mount, and email sales@trollingmotorsdirect.org with your boat and mount if you’d like us to check the fit.

error: Content is protected !!