Description
This battery terminal set is for the boat where every graph, pump and charger has its own wire on the battery, and the terminal cover won’t close anymore. Instead of stacking ring terminals on one post, these terminals give the extra wires their own place to land. The covers still go on over everything.
Check your battery posts first
Fit comes down to the post on your battery:
- Fits 8mm, 5/16 inch and 3/8 inch battery bolts.
- Does not fit tapered post batteries, the round cone posts found on most car batteries.
- The bolt that attaches the terminal to the battery is not included.
Most deep cycle and lithium batteries used on fishing boats have threaded studs or bolt-in terminals, but check yours before ordering. The battery terminal article on Wikipedia shows the common post styles side by side.
What’s in the battery terminal set
- 2 terminals
- 2 covers
- 2 cover bolts
- 2 side bolts
Not included: the bolt to the battery. Use the bolt that came with your battery, or pick one up in the right size for your post. Everything else you need to finish the job comes in the battery terminal set.
Wire size range
The terminals accept wire from 22 gauge up to 8 gauge. On the American wire gauge scale, a smaller number means a thicker wire, so 8 gauge is the heaviest wire these take. That covers the usual accessory runs: graphs, livewell and bilge pumps, lights and onboard chargers.
If your trolling motor or main battery leads are heavier than 8 gauge, they’re outside this range. In that case the battery terminal set still handles the small accessory wires, and the heavy leads stay on their own lugs.
Installing the battery terminal set
Disconnect the negative cable first and reconnect it last. Crimp proper lugs or ferrules on each wire, then fasten them under the side bolts so nothing is loose. Fit the terminal covers before the boat goes back in the water. They keep a dropped wrench or loose tool from shorting across the posts.
If those wires pass through a console or deck panel on the way to the battery, our Wire Puck keeps them neat where they go through the hole.
Common questions
Will the battery terminal set fit a car style tapered post?
No. It fits 8mm, 5/16 and 3/8 inch battery bolts only.
Do I get terminals for both posts?
Yes. The kit has two terminals and two covers, one for each post.
What if it doesn’t fit my battery?
Send it back unused within 30 days. It isn’t an electronic item, so our normal returns policy applies.
For more on boat batteries, read our trolling motor battery guide, or browse more accessories. Email sales@trollingmotorsdirect.org with your battery model if you’d like us to check the posts.
















