Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Console Double Mount

$300.00

Mounts two graphs on the console. Made for the SeaArk Flex, and may fit other boats and models. Black anodized aluminum with stainless steel hardware. Mounting hardware not included.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The SeaArk Flex console double mount puts two graphs side by side on the console. It was made for the SeaArk Flex, though it may fit other boats and models too. It’s aluminum with stainless steel hardware and a black anodized finish.

Why run two graphs at the console

The console is where you run the boat, so it’s where you want a big map and a good sonar view at the same time. Two graphs means you don’t have to flip between split screens while you’re idling over a ledge or following a contour. One shows the chart, the other shows what’s under the boat.

A two-screen console also gives you a backup. If one unit has trouble on the water, the other can still get you home. With the SeaArk Flex console double mount, both units sit on one mount instead of two separate brackets drilled into the dash.

Fit on the Flex and other boats

The SeaArk Flex console double mount was designed around the Flex console, so that’s where it fits best. It may also work on other boats with a similar console face. Before ordering for a different boat, measure the flat area where it’ll bolt and check for room behind the console for nuts and wiring.

If you send us a couple of photos of your console with a tape measure in the frame, we can usually tell you whether it’ll work.

What you get

ItemDetail
Screens2 graphs on the console
Designed forSeaArk Flex (may fit others)
MaterialAluminum
FinishBlack anodize
HardwareStainless steel
Console mounting hardwareNot included

Installing two graphs on the console

Fit the mount, then hold both graphs up in their gimbals before you drill anything. Check you can still see over them, reach the throttle and steering, and read both screens from the seat. Run power and transducer cables behind the console and leave slack so the screens can tilt.

Use stainless bolts sized for your console and back them with washers or a backing plate on the inside. If you’d rather angle the screens toward you, the console double swivel mount lets both graphs swivel. For general background on what each unit does, Wikipedia’s fishfinder page is a good start.

Questions

Will the SeaArk Flex console double mount fit my boat?

It’s made for the Flex and may fit other consoles. Send us your console measurements to check.

Is the bolt kit for the console included?

No. Mounting hardware isn’t included because console thickness varies. Pick stainless bolts long enough to pass through the SeaArk Flex console double mount, the console wall and a washer on the back.

See more in our console mounts and SeaArk sections, or email sales@trollingmotorsdirect.org with your boat and graphs.

Related products

error: Content is protected !!