Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

MEGA CA Base

$59.00

Fits the underside of our MEGA base adaptor plate and hides the hole where the wires come through, for a cleaner install. Black powder coated aluminum, machined in the USA.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The MEGA CA base goes on the underside of our MEGA base adaptor plate and hides the hole where your wires come through. It’s a small part that makes for a very clean install, with no open hole showing at the base of your graph mount.

What the MEGA CA base is for

Run power and sonar cables up through the deck to a graph and you end up with a hole right where everyone can see it. Add this base to the underside of the MEGA base adaptor plate and that hole is covered. It’s black powder coated aluminum, machined in the USA, so it matches the black powder coated MEGA plate it attaches to.

What it works with

It’s made for our MEGA base adaptor plate, listed in the shop as the Mega Mount Adapter Plate. That plate enlarges the attachment area for our single, double, telescoping and over the side mounts, and it’s included with our deck mounts for big screens like the Lowrance HDS 16 deck mount.

We also list a separate CA Base. If you’re not using the MEGA plate, ask us which one suits your mount before ordering.

Planning the cable run

The MEGA CA base covers the hole, but the hole still needs to be done right:

  • Size: drill for the largest connector that has to pass through, not just the cable.
  • Seal: seal the hole through the deck so water can’t get into the core or the hull.
  • Slack: leave enough cable for the mount to swivel or the graph to tilt without pulling.
  • Drip loop: let cables dip below the connector so water runs off rather than into it.

Do the cable work before the plate goes down for good. Once the mount, plate and base are bolted in place, it’s much harder to add another cable later, so if you think you’ll add a second graph or a live sonar unit, pull an extra cable or a draw line through the hole now.

Build

ItemDetail
FitsUnderside of the MEGA plate
JobHides the hole where the wires come through
FinishBlack powder coat
MaterialAluminum
Made inMachined in the USA

Questions

Does the MEGA CA base include the plate?

No. The plate is its own listing; this is the base that goes under it.

Do I need it?

The mount works without it. The MEGA CA base is there for a tidier look around the wire hole.

Can I return it?

If it’s unused, you have 30 days to send it back; see our returns page. Other plates and bases are listed under mount plates.

Email sales@trollingmotorsdirect.org with your mount and plate, and we’ll confirm the MEGA CA base is the right part.

Related products

error: Content is protected !!