Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Mega Mount Adapter Plate

$59.00

A 1/2 inch thick black powder coated aluminum plate that enlarges the attachment area under our single, double, telescoping and over the side mounts. Made for thin decks like aluminum boats. Plate only.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

On an aluminum boat with a thin deck, the Mega Mount Adapter Plate gives our graph mounts a bigger, steadier footprint. It was designed in response to requests for a plate that would enlarge the attachment area and stabilize our double and single mounts. It works on other decks too, but thin ones benefit most.

Mega mount adapter plate, top view of the 1/2 inch black powder coated aluminum plate

How the mega mount adapter plate works

  1. Fasten the plate to your boat. Deck mounting hardware is not included.
  2. Set your mount on the plate.
  3. Attach the mount to the plate with the screws provided.

The mount’s load now spreads across the whole plate instead of a few screws in a thin deck. Add an under plate below the deck and the deck is sandwiched between two plates, which is how our big-screen deck mounts come set up. Under plates are in our mount plates section.

Mounts it fits

Our Folding Single Mount without Bridge listing also recommends it, with an under plate, for aluminum decked boats.

Before you install

  • Placement: set the mount and graph on the plate and check sight lines, casting room and trolling motor clearance before drilling the deck.
  • Fasteners: pick stainless deck hardware long enough to pass through the plate, the deck and an under plate if you use one.
  • Wires: plan where the cables come up through the deck, since the plate covers that spot.

Specs

ItemDetail
Thickness1/2 inch
MaterialBlack powder coated aluminum
IncludedThe adapter plate and screws to attach your mount to it
Not includedDeck mounting hardware; the mount shown in the photos

Why thin decks need it

A graph on a tall arm acts like a lever. Every wave pushes on it, and on a thin aluminum boat deck that force lands on a few screws in a small area. Over time screws work loose or the deck flexes around them. A wider, 1/2 inch plate gives the mount a solid base and spreads that force out.

To hide the hole where wires come up under the plate, add the MEGA CA base to its underside.

Questions

Is the mount included with the mega mount adapter plate?

No. This listing is the adapter plate only; the mount in the photos is not included.

Will it help on a fiberglass boat?

It enlarges the attachment area on any deck. It’s most useful where the deck is thin.

Is there a discounted one?

Sometimes. See the mega mount adapter plate in scratch and dent.

Email sales@trollingmotorsdirect.org with your mount and deck type, and we’ll tell you if you need the plate and an under plate.

Related products

error: Content is protected !!