Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Lowrance 000-15278-001 Rod for Ghost

$51.00

Lowrance replacement rod stabilizer kit (000-15278-001) for the Ghost trolling motor’s built-in stabilizer bar. Includes the rod, a 3/4-10 nylon nut, the stabilizer foot and the top cap. Expect to cut the rod to fit.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

A bent rod or a worn rubber foot lets a stowed Ghost bounce on its mount, and the Lowrance Ghost rod stabilizer kit (000-15278-001) replaces both, along with the small parts that go with them. That rod and foot are what keep the motor steady when you run on plane in rough water. If the old rod was cut too short at install, this kit fixes that too.

What’s in the kit

  • The stabilizer rod
  • A 3/4-10 nylon nut
  • The stabilizer foot
  • The top cap

It’s the Lowrance part for the stabilizer bar built into the Ghost’s mount. It isn’t the Live Sweep stabilizer for Lowrance Ghost, which is a separate clamp that supports a Live Sweep on the shaft.

Setting the rod length

The stabilizer rod gets cut to fit your boat when the motor is installed. Lowrance’s install steps have you stow the motor, mark the rod 3/4 in past the top of the adapter and cut it there. Do the same with the new rod, and measure twice, since you can’t add length back.

Once it’s on, the Ghost owner’s manual gives a quick check to do before each use. With the motor stowed, lift it slightly. The gap between the deck and the rubber foot on the stabilizer bar should be less than 1/2 in (13 mm), and the stabilizer jam nut should be tight. The maintenance schedule says to adjust and tighten the lock nut as needed.

Signs you need the Lowrance Ghost rod stabilizer kit

  • The rubber foot is split, flattened or missing.
  • The rod is bent from a hard hit or a rough tow.
  • The gap at the foot won’t stay under 1/2 in however you adjust it.
  • The rod was cut too short on an earlier install.

A loose or worn stabilizer lets the stowed motor slap the mount, and that load goes into the deck. It’s cheap insurance next to a cracked mount. Our trolling motor mount guide explains why stowed motors bounce, and the Lowrance Ghost guide covers the install in more detail.

Common questions

Will the Lowrance Ghost rod stabilizer kit fit a Recon?

Our listing names it for the Ghost. The Recon uses a pivot-style mount, so email us before ordering any stabilizer part for one.

Do I need to cut the new rod?

Expect to. Lowrance’s install steps size the rod to your boat with the motor stowed.

How often should I check the stabilizer?

Before each use, per the Ghost manual. The kit is final sale like our other electronics (returns policy), and more Ghost spares are in Lowrance trolling motor accessories.

Email sales@trollingmotorsdirect.org with your Ghost’s shaft length and a photo of the old rod if you’d like us to confirm the Lowrance Ghost rod stabilizer kit is the right part.

Related products

error: Content is protected !!