Description
This Lowrance Active Imaging 2-in-1 in-hull Y-cable kit lets an Elite Ti2 or Elite FS run two transducers off its one sonar port. You get an Active Imaging 2-in-1 for SideScan and DownScan, an 83/200 kHz puck that mounts inside the hull for traditional sonar, and the dual 9-pin Y-cable that joins them. Lowrance part number 000-15813-001.
What’s in the box
- Active Imaging 2-in-1 transom transducer (SideScan and DownScan)
- 83/200 kHz pod/puck transducer for in-hull mounting, without temperature
- Dual 9-pin Y-cable
Why split the work between two transducers
The 2-in-1 handles imaging only. Lowrance’s stand-alone Active Imaging 2-in-1 runs at 455 and 800 kHz, with SideScan range out to 300 ft per side at 455 kHz and 150 ft at 800 kHz. Traditional sonar comes from the puck instead.
Mounting that puck inside the hull has two upsides. There’s no second set of holes in the transom, and because it isn’t sitting in the turbulent water behind the boat, an in-hull puck transducer often holds a bottom reading better at speed.
Check your hull before ordering the Active Imaging 2-in-1 in-hull Y-cable kit
In-hull pucks shoot through solid fiberglass. They won’t read through aluminum, and cored sections (foam or balsa sandwiched in the laminate) block the signal. Find a spot in the bilge with solid glass, ideally near the stern and clear of strakes.
Before you bond it in, test the spot. Many installers set the puck in a little water on the hull, run the boat and check for a clean bottom reading before committing. If your boat is aluminum, the skimmer version of this kit is the one to buy.
Wiring both to one sonar port
In the Active Imaging 2-in-1 in-hull Y-cable kit, each transducer plugs into its own leg of the Y-cable, and the single end goes into the 9-pin sonar port on the display. Once powered up, set the sonar sources so each page reads from the right transducer.
The Elite FS line is built around Active Imaging. Lowrance’s Elite FS page describes it as Active Imaging 3-in-1 ready, and this kit is the way to add side imaging while keeping traditional sonar on its own puck. For more Lowrance options see our Lowrance transducers, and our Lowrance fish finder guide compares the displays.
Questions
Does the 000-15813-001 work on an HDS?
Lowrance lists it for the single sonar port of the Elite Ti2 and Elite FS. HDS models aren’t named, so ask us before ordering for one.
Will I get water temperature?
Not from the puck, which is listed without a temperature sensor. Lowrance’s stand-alone Active Imaging 2-in-1 lists temperature among its outputs, so ask us if you want to confirm temp on this kit.
Can I return the Active Imaging 2-in-1 in-hull Y-cable kit?
No. Like everything electronic we sell, it’s final sale once ordered. Our returns policy spells it out.
Email sales@trollingmotorsdirect.org with your boat, hull material and display model, and we’ll tell you if this kit is the right fit.









