Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Wire Puck XL

$56.00

A taller version of our wire puck, with a 1 1/2 inch outlet for boats running more electronics cables through one panel. High density polyethylene, grommet for a 1 5/8 inch drilled hole.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The wire puck XL is the taller version of our wire puck, for boats where one panel pass-through has to handle a lot of cables. Its outlet stands 1 1/2 inches tall, which is 1/2 inch taller than the original. Everything else, from the diameters to the 1 5/8 inch hole it fits, stays the same.

Why the taller outlet helps

Once you’re running a couple of graphs, a forward facing sonar unit, side imaging and power through the same hole, a standard puck gets crowded. The extra half inch of height gives that bundle more room to organize as it comes out of the panel.

More room means cables aren’t forced into tight bends right at the exit. That’s easier on the cables, and it makes adding one more later less of a squeeze.

If you know more electronics are coming, such as a second screen next season, it’s simpler to put the wire puck XL in now than to rework the panel later.

Wire puck XL dimensions

ItemDetail
Outside diameter2.860 in
Inside diameter1.970 in
Outlet height1 1/2 in (1/2 in taller than the original)
MaterialHigh density polyethylene
Hole sizeGrommet for a 1 5/8 in drilled hole

XL, original or extender

We sell three ways to get this job done, and the right one depends on where you’re starting:

  • New install with lots of cables: the wire puck XL.
  • New install with a few cables: the original Wire Puck, 1 inch tall.
  • Already have an original puck installed: the Wire Puck Extender adds 1/2 inch to it.

Because the outside diameter and hole size are the same across the range, moving up to the taller outlet doesn’t mean drilling a bigger hole.

Putting the XL in

Measure your largest plug before you drill. Every connector has to fit through the 1 5/8 inch hole, and transducer plugs tend to be the biggest. Clean the edge of the hole after drilling, seat the grommet, feed the cables and set the puck in place.

The listing doesn’t say what mounting hardware comes with the XL, so check with us if you need to know before your install day.

Common questions

Is the wire puck XL wider than the original?

No. Both are 2.860 inches outside and 1.970 inches inside. Only the outlet height changes.

Do I need a bigger hole for the XL?

No. It uses the same 1 5/8 inch drilled hole.

Can I stack an extender on the XL?

The extender is listed for the original Wire Puck. Email us before trying it on an XL.

Compare all our wire puck parts, or email sales@trollingmotorsdirect.org with the cables you’re running and we’ll suggest the right one.

Related products

error: Content is protected !!