Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin White Round Nose Cone

$119.99

Garmin round nose cone in white (010-12832-23) for Force trolling motors. Use it to replace the standard nose cone or when mounting equipment with traditional clamps. It doesn’t hold a transducer inside.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The Garmin white round nose cone (010-12832-23) is a round replacement nose for the lower unit of a Garmin Force trolling motor. Use it to replace a damaged standard nose cone, or to give clamp-on equipment a round surface to grab. It does the same job as Garmin’s black round cone, finished in white.

Three Garmin nose cones, three jobs

Nose conePart numberUse it for
White round010-12832-23Replacing the standard part, or mounting equipment with clamps
Black round010-12832-22The same jobs, in black
GT transducer010-12832-21Holding a Garmin GT22, GT24, GT52, GT54 or GT56 transducer

If you want a transducer inside the nose, the round cones are the wrong part. Look at the GT transducer nose cone instead. For the round shape in a darker finish, the black round nose cone is the match.

Fitting the Garmin white round nose cone

The nose cone comes off with the skeg. Garmin’s Force owner’s manual gives the order. Disconnect the battery first and keep every screw.

  1. Remove the four screws holding the skeg with a 4 mm hex key.
  2. Remove the screw at the bottom that secures the transducer and nose cone, using a 3 mm hex key.
  3. Remove the screws holding the nose cone to the front of the motor with a 4 mm hex key.
  4. Fit the new cone, refit its screws, then put the skeg back on.

There’s an anode behind the nose cone, held by a 3 mm screw. While you’re in there, Garmin says to clean it if it’s at least half its original size and replace it if it’s smaller.

Clamp-on gear

Garmin lists this cone for mounting equipment with traditional clamps, and a round nose gives band-style clamps an even surface to grip. Tighten clamps evenly and check them after the first few trips. A clamp that walks on the lower unit scuffs the finish, and scuffs show more on a Garmin white round nose cone than on the black one.

Nose cone questions

Does the Garmin white round nose cone hold a transducer?

No. Garmin lists it for replacing the standard part and for clamp-on equipment. For a GT transducer inside the nose, get the GT transducer nose cone.

Will it fit my Kraken or Force Pro?

It’s sold as a part for Force motors. Email us your model before ordering, since Garmin parts are final sale under our returns policy.

Do I need new screws?

Garmin’s steps reuse the screws you take out, so don’t lose any. The rest of our Garmin spares are in Garmin trolling motor accessories.

If you’re unsure which nose cone suits your motor or the gear you’re clamping on, email sales@trollingmotorsdirect.org with your boat and Garmin motor model and we’ll help.

Related products

error: Content is protected !!