Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Wire Puck

$46.00

A high density polyethylene wire puck that organizes and protects wires where they pass into a console or deck panel. Grommet for a 1 5/8 inch drilled hole and stainless steel hardware.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Graph, transducer and power cables all have to pass through a panel somewhere, and the wire puck keeps that pass-through tidy and protected. It sits over a 1 5/8 inch drilled hole, with a grommet that cushions the cables against the edge of the hole. The result is a clean exit point on a console or deck instead of a ragged hole with wires chafing on it.

What it does

Cables that rub on a drilled edge eventually wear through their jacket. On a boat, that means corrosion, intermittent faults and a graph that cuts out on a bumpy ride. A grommet lines the hole so the insulation isn’t sawing against fiberglass, aluminum or plywood every time the boat flexes.

The puck around it organizes the bundle so the wires come out in one neat spot. It’s much easier to trace a problem later when everything runs through one place.

The usual spots are where cables leave the console for the bow, where they drop from the dash into the hull, and where a transducer cable comes up through the deck. Anywhere a bundle passes through a flat panel, it’s a good candidate.

Wire puck dimensions

ItemDetail
Outside diameter2.860 in
Inside diameter1.970 in
Height1 in
MaterialHigh density polyethylene
Hole sizeGrommet for a 1 5/8 in drilled hole
HardwareStainless steel

Installing it

Plan the hole around your biggest plug. Every connector has to pass through a 1 5/8 inch hole, so check the largest one (often a transducer plug) before you drill. Some plugs are close, and it’s better to find out with a tape measure than with a stuck connector.

Drill the hole with a hole saw, clean up any burrs, and test fit the grommet. Feed the cables, seat the puck and fasten it down with the stainless hardware. Leave a little slack below the panel so cables aren’t pulled tight against the grommet.

When the puck fills up

As you add electronics, a standard puck can fill up. Two options give you more space:

  • Wire Puck XL: same diameters with a 1 1/2 inch tall outlet, 1/2 inch taller than this one.
  • Wire Puck Extender: adds 1/2 inch of height to a puck you already have.

Questions we get

What size hole does the wire puck need?

A 1 5/8 inch drilled hole. The grommet is sized for that.

What’s it made of?

High density polyethylene, which won’t rust or rot, with stainless steel hardware.

Will a transducer plug fit through?

Every plug has to pass through the 1 5/8 inch hole, so measure your largest connector before you drill.

See all the wire puck parts we carry, or email sales@trollingmotorsdirect.org with what you’re running through the panel and we’ll help you pick the right size.

Related products

error: Content is protected !!