Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Bridge Under Plate

$46.00

A tumbled 6061 aluminum plate that goes under the deck below your bridge to lessen flex. Stainless steel hardware. Fits all our bridges except the Bass Cat bridge. Best on aluminum decks.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

A bridge under plate goes beneath the deck, directly under your bridge, so the deck is sandwiched between the two. That cuts down deck flex and gives the bridge a much firmer base for the screens on top. It’s 6061 aluminum with a silver tumbled finish, and it comes with stainless steel hardware.

Why put a plate under the deck

A bridge bolted through a thin deck relies on a few small washers to hold it down. Every time the bow slams or you step hard on the pedal, the deck flexes around those washers, and the screens wobble. Over a season, that motion can also loosen bolts or crack a soft deck around the holes.

The bridge under plate spreads the clamp load across a wide strip of deck. The bridge bolts pull against solid aluminum underneath instead of a washer, so the whole assembly moves as one piece.

Which bridges it fits

It fits every bridge we sell except one. The Bass Cat bridge is the exception. Everything else, from our standard bridge mount to the extenders, offsets and triple bridge, works with it.

Bridge under plate details

  • 6061 aluminum
  • Silver tumbled finish
  • Stainless steel hardware
  • Helps lessen deck flex
  • Recommended for aluminum decks, usable on any deck material

A tumbled finish is bare metal smoothed by tumbling in media, so there’s no coating to scratch off under the deck where you’ll rarely see it anyway.

Aluminum decks and other decks

Aluminum decks benefit most because they’re thin and springy. That said, the plate can be used with any deck material. Some carpeted plywood decks are soft from years of water, and a plate underneath gives the bolts something better to grab.

On aluminum decks you can go one step further and pair it with the Bridge Multi Mount Plates on top, so the deck is backed from both sides.

Fitting it

Bolt the bridge in place first, loosely, then reach under the deck and line up the plate with the bolts. You’ll need access from below, through a hatch, a storage box or an access hole. Snug the bolts evenly from both sides and seal the holes on top.

If you have to cut an access hole to reach the bridge under plate, our deck access cover closes it up neatly afterward.

Questions

Does the bridge under plate fit the Bass Cat bridge?

No. It fits all our other bridges, but not the Bass Cat model.

Do I need it on a fiberglass deck?

It’s recommended for aluminum decks, but it works on any deck. If your deck feels soft or flexes, it’s worth adding.

Other plates and bases are listed under mount plates. Email sales@trollingmotorsdirect.org with your bridge and deck type, and we’ll confirm the fit.

Related products

error: Content is protected !!