Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Live Sweep Power Pole ZR Mount Only

$172.00

CNC machined aluminum bracket, black powder coated, that carries a Live Sweep on a Power-Pole MOVE ZR trolling motor. Stainless steel mounting hardware included. Made and assembled in the USA.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

On a Power-Pole MOVE ZR, the Live Sweep Power Pole ZR mount is the machined bracket the sweeping arm hangs from. It’s CNC machined aluminum in black powder coat, comes with stainless steel mounting hardware, and is made and assembled in the USA.

Live Sweep Power Pole ZR mount machined bracket

Bracket only, or the full set

This listing is the bracket with its stainless hardware. If you also need the dog bone that goes with it, the Live Sweep Power Pole ZR mounting hardware is the mount and dog bone together.

Buy the bracket alone when the rest of your ZR parts are fine: a bent bracket, a second ZR boat, or a rebuild where you’re replacing only what’s damaged. A brand new Live Sweep for a ZR is easiest ordered with the Power Pole ZR option on the Live Sweep with mounting hardware.

Either side of the motor

The ZR mount is designed for port or starboard, so there’s one part rather than two. Pick the side that gives your cables the shortest clean run back toward the console and keeps the arm away from where you stand to fish.

Live Sweep Power Pole ZR mount specs

  • Fits the Power-Pole MOVE ZR trolling motor
  • Holds a Live Sweep
  • CNC machined aluminum
  • Black powder coated finish
  • Stainless steel mounting hardware
  • Made and assembled in the USA

Power-Pole’s MOVE ZR page has the motor’s own specs if you need to confirm your model.

Install notes

Keep the old bracket until the new Live Sweep Power Pole ZR mount is on and tested, so you have something to compare against if a bolt hole or angle looks different.

Start the stainless bolts by hand, then tighten them in turn. Route the Live Sweep and transducer cables so nothing pulls when the ZR stows, and cycle the motor a few times at the dock. Rinse with fresh water after salt trips; powder coat holds up well, but salt crystals left in the joints do no favors to any aluminum part.

If your ZR bounces in a chop, have a look at the Power Pole ZR Bounce Eliminator Kit as well.

ZR questions

Does the Live Sweep Power Pole ZR mount fit the MOVE PV?

No. PV owners need the complete Live Sweep for Power Pole PV.

Do I need special tools?

No special tools are listed. Ordinary hand tools for the stainless hardware will do it.

Is a dog bone included?

No, only the mount and its stainless hardware. The mounting hardware listing adds the dog bone.

See more under Live Sweep mounts and parts, or email sales@trollingmotorsdirect.org with your ZR model and what you already have, and we’ll tell you which part fills the gap.

Related products

error: Content is protected !!