Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin Transducer Replacement for Force

$39.99

Garmin installation kit (010-12832-25) for replacing or upgrading the transducer built into a Force trolling motor. Includes a compression seal wrench, two no-transducer seals and three 12-pin seals. It is not a transducer.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

Swap or upgrade the transducer built into a Garmin Force trolling motor and you’ll need the Garmin Force transducer replacement kit (010-12832-25). Despite the name, it isn’t a transducer. It’s the wrench and compression seals that let the cable pass through the motor and still keep the factory waterproof seal.

What’s in the box

  • 1 compression seal wrench
  • 2 no-transducer compression seals
  • 3 12-pin transducer compression seals

The 12-pin seals are for a transducer with a 12-pin connector, the type Garmin builds into the Force Pro. The no-transducer seals are listed for running the motor without a transducer cable. The seal wrench is the tool for tightening and loosening them.

When you need the Garmin Force transducer replacement kit

Garmin’s note with this kit says to replace all O-rings and compression seals whenever you use it, so the motor returns to its original factory waterproof sealing. An old seal has already been squeezed into shape once. Reusing it is how water gets into a lower unit.

  • A failed built-in transducer: new transducer, new seals.
  • An upgrade: our GT transducer nose cone takes Garmin GT22, GT24, GT52, GT54 and GT56 transducers, and its listing recommends this kit if you’re routing a new transducer through the shaft.
  • Running with no transducer: that’s where the two no-transducer seals come in.

Before you open the motor

The box list covers the seal wrench and the seals. It doesn’t list O-rings. Garmin’s advice is to replace those too, so check yours once the motor is apart and email us if they’re flattened or nicked.

Garmin’s Force owner’s manual covers taking off the skeg and nose cone, and it points to a separate field service manual for detailed service work. Read the steps for your exact model first. Disconnect the battery, keep every screw, and take a phone photo of the cable routing before you pull anything.

Kraken owners need the Kraken version of this kit, which adds an 8-pin seal, an O-ring kit and stainless screws. The rest of our Garmin parts are in Garmin trolling motor accessories.

Questions about the Force kit

Does the Garmin Force transducer replacement kit include a transducer?

No. It’s the seal wrench and seals only. The transducer and any nose cone are separate parts.

Will it fit a Force Kraken?

We list it for Force motors. The Kraken has its own kit (010-12832-26) with a different seal set, so order that one for a Kraken.

Can I return it if I don’t use it?

Even unopened, no. Garmin parts sit in our electronics range, which is final sale under our returns policy. Ask us before ordering if you’re not sure which kit you need.

Email sales@trollingmotorsdirect.org with your Force model and the transducer you’re fitting, and we’ll go through the Garmin Force transducer replacement kit and anything else the job needs.

Related products

error: Content is protected !!