Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Garmin 010-12938-00 Powercord Echomap Ultra 102 106 122 126 4 PIN

$29.99

Garmin’s threaded 4-pin power/data cable, part 010-12938-00. It’s 6 ft (2 m) long with NMEA 0183 input and output, for the first-generation ECHOMAP Ultra 102, 106, 122 and 126.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

If the lead on your graph is cut, corroded or missing, this ECHOMAP Ultra 4-pin power cable is Garmin’s replacement, part 010-12938-00, which Garmin calls the Threaded Power/Data Cable (4-pin). It’s 6 feet (2 meters) long, it powers a compatible ECHOMAP Ultra chartplotter/sounder combo, and it carries NMEA 0183 input and output wires for older-style data connections.

Which ECHOMAP Ultra 4-pin power cable fits your unit

We list it for the first-generation ECHOMAP Ultra 102, 106, 122 and 126. Those are the 10-inch and 12-inch Ultra models. Garmin’s own listing describes it simply as the cable for compatible ECHOMAP Ultra units.

A few things it is not:

  • Not a GPSMAP cable. GPSMAP 7×2 through 12×2 units use an 8-pin cable, which we sell separately as the Garmin power/data cable for GPSMAP.
  • Not listed for the Ultra 2. ECHOMAP Ultra 2 units ship with their own power/data cable, and we don’t list this part for them. Ask us if you need a spare for an Ultra 2.
  • Not a transducer or network cable. It handles power and NMEA 0183 data only.

The quickest check is the socket on your unit or cradle. Count the pins and compare the old plug if you still have it.

Wiring it in

Follow the wiring section in your ECHOMAP Ultra install manual for fuse size and wire colors. In general terms, the power leads should go to a fused circuit, either at a fuse block or a breaker panel, and the graph should share a common ground with your other electronics. That keeps sonar noise down and makes troubleshooting easier.

The ECHOMAP Ultra 4-pin power cable is six feet long, which reaches the fuse block in many consoles. If your run is longer, extend the power leads with properly sized wire and sealed connections rather than stretching the cable tight.

Thread the connector on by hand until it’s snug. Don’t use pliers on the collar.

What the NMEA 0183 wires are for

NMEA 0183 is the older serial data standard, and plenty of boats still have gear that talks that way. Typical uses are sending GPS position to a VHF radio for DSC distress calls, or swapping data with an older autopilot or sensor. If you don’t have anything like that, insulate and tie back the data wires and use only the power leads.

Newer gear usually connects over NMEA 2000 instead, which is a separate connection on the unit.

Questions about this cable

How long is it?

6 feet, or 2 meters, per Garmin.

Is it a genuine Garmin part?

Yes, part number 010-12938-00. Garmin’s listing is on its product page.

Can I send it back if it doesn’t fit?

Electronics are final sale here, as our returns policy explains. Please confirm your model first.

Other covers, mounts and cables are in Garmin graph accessories. If you’re unsure your graph takes the ECHOMAP Ultra 4-pin power cable, email sales@trollingmotorsdirect.org with the model from the back label and we’ll check. We answer Monday to Friday, 9am to 6pm.

Related products

error: Content is protected !!