Description
Packed with our XPLORE CMSI+ kits and sold here on its own, the Humminbird XM 14 HW CMSI T (model 710311-1) is a compact MEGA Side Imaging+ transom mount transducer for APEX, SOLIX G3 and XPLORE units. One ducer covers MEGA Side Imaging+, MEGA Down Imaging+ and Dual Spectrum CHIRP, and it reads water temperature too.
Frequencies and range
| Mode | Frequency | Max range |
|---|---|---|
| Compact MEGA Side Imaging, 455 kHz | 405-505 kHz | 800 ft (244 m) side to side |
| Compact MEGA Side Imaging, MEGA | 1.100-1.200 MHz | 400 ft (122 m) side to side |
| Compact MEGA Down Imaging, 455 kHz | 420-520 kHz | 400 ft (122 m) depth |
| Compact MEGA Down Imaging, MEGA | 1.125-1.225 MHz | 400 ft (122 m) depth |
| Dual Spectrum CHIRP | Full 150-220 kHz, Narrow 180-240 kHz, Wide 140-200 kHz | Not listed |
Humminbird XM 14 HW CMSI T specs
- Compatible with APEX, SOLIX G3 and XPLORE fish finders
- Transom mount
- 20 ft cable with a screw-on connector
- Built-in temperature sensor
- 1-year limited warranty
Who it’s for
- Anyone running a head-only unit such as the Xplore 9 with no transducer who wants a standard transom ducer
- Owners replacing a damaged XM 14 HW CMSI T after a stump or trailer strike
- APEX or SOLIX G3 owners who want a compact imaging ducer on a smaller transom
Our APEX kits ship with the XM 14 HW MSI T, a different, non-compact transducer. The Humminbird XM 14 HW CMSI T is the compact version, and it’s also on the APEX compatibility list.
Getting a clean picture from the transom
Side imaging is fussy about water flow. Mount the transducer where water leaves the hull smoothly at speed, away from strakes, rivets, livewell pickups and the prop. Set the angle and height by Humminbird’s instructions, then fine-tune on the water: if the bottom drops out at speed, adjust it a little lower and check again. Seal every screw hole with marine sealant.
Route the 20 ft cable to the console through existing rigging paths and keep it apart from outboard and trolling motor power leads to cut down on interference.
Questions
Will the Humminbird XM 14 HW CMSI T work with my HELIX?
HELIX isn’t on its list. It’s listed for APEX, SOLIX G3 and XPLORE.
Is the 20 ft cable long enough?
Measure from the transom spot to the graph along the real route, including any rise up into the console, before you mount anything. If the run is longer than 20 ft, email us before ordering.
Does it show water temperature?
Yes, it has a built-in temperature sensor.
Transducers count as electronics, so it’s final sale under our returns policy. Browse other Humminbird transducers, read our Humminbird fish finder guide, or see Humminbird’s fish finder lineup. Email sales@trollingmotorsdirect.org with your graph model and boat and we’ll confirm this is the right transom mount transducer.










