Description
Most console installs need at least one cable about this length, and the Lowrance N2KEXT-6RD NMEA 2000 cable is that cable. It’s a 6 ft extension for the red Lowrance network, long enough to run from a tee under the console up to a display on the dash with a service loop to spare. Lowrance also lists it for the LGC-3000 GPS antenna.
The typical 6 ft job
The backbone usually runs low in the console, out of the way. The display sits up top. A 6 ft drop cable bridges that gap with enough slack that you can pull the display forward to clean the screen or change a card without unplugging anything.
If your display sits on a swivel or folding mount, leave enough slack behind it for the full range of movement. A cable that goes tight when the display swings will work loose or crack at the plug over time.
It works as a backbone link too, for example between a cluster of tees at the helm and a second cluster a few feet away under a seat.
Drop length rules
NMEA 2000 allows a device to sit up to 6 m from the backbone, according to the standard’s summary on Wikipedia. At 6 ft (under 2 m), the Lowrance N2KEXT-6RD NMEA 2000 cable is nowhere near that, so you can use it as a drop anywhere without worrying about the limit.
What matters more is how you route it. Keep it away from the bilge and from spots where wash-down water collects, and tie it so it can’t rub on sharp edges inside the console.
Choosing between lengths
| Cable | Length | Typical use |
|---|---|---|
| N2KEXT-2RD | 2 ft | Spacing tees, very short drops |
| N2KEXT-6RD | 6 ft | Tee to display behind the dash |
| N2KEXT-15RD | 15 ft | Longer drops, mid-boat backbone |
| N2KEXT-25RD | 25 ft | Backbone runs to bow or stern |
The 15 ft N2KEXT-15RD is the next step up if 6 ft won’t reach.
Lowrance N2KEXT-6RD NMEA 2000 cable questions
Can I use the Lowrance N2KEXT-6RD NMEA 2000 cable with an LGC-3000?
Yes. Lowrance lists it for the LGC-3000 GPS antenna as well as the red network in general.
Does it carry power as well as data?
Yes. NMEA 2000 cables carry both, which is how sensors on the network get their power from the backbone.
Will it work on my red Lowrance network?
Yes, it’s a red-network part. Check that your tees and terminators are the RD type too.
Is it final sale?
Yes. It’s an electronics part (see returns).
Email sales@trollingmotorsdirect.org with where your tees and displays are mounted, and we’ll help you pick lengths. Our network parts are in Lowrance graph accessories.









