Skip to content

Garmin · Lowrance · Humminbird trolling motors, live sonar and the mounts to rig them

Mon–Fri, 9am–6pmsales@trollingmotorsdirect.org

Pontoon Rail Clamp 1 1/4″ fits Swivel Base

$75.00

Clamp that lets you mount an Over the Side Mount on a pontoon boat. Fits 1 1/4 inch square rail and the swivel base. Black anodized aluminum with stainless hardware. Swivel base not included.

  • Free ground shipping on orders of $199+ to the lower 48
  • Not sure it fits? Email us before you order
  • Warranty by the manufacturer · Returns

Description

The pontoon rail clamp lets you mount an Over the Side Mount on a pontoon boat’s rail. It fits 1 1/4″ square rail and takes the swivel base, which isn’t included. It’s black anodized aluminum with stainless steel hardware, machined and assembled in the USA.

What it fits

  • Rail: 1 1/4″ square rail. Measure across the flat of yours before ordering.
  • Base: the swivel base our Over the Side Mount uses. The base is sold separately.
  • Tools: standard Allen wrenches.

Round rail needs a different part. Our round rail mount covers 3/4″ to 1″ round rail.

Why pontoons need their own clamp

Pontoon decks usually have furniture and fencing around the edge, so there isn’t always a good spot to bolt a base down near the water. Clamping to the rail puts the mount out over the side where the transducer needs to be, and you aren’t drilling the deck to get it there.

Pontoons also have room for more than one fishing spot. With a pontoon rail clamp on each side and a mount on each, two people can run their own live sonar off the same boat.

Pontoon rail clamp build

It’s machined from aluminum and black anodized, then assembled in the USA. The hardware is stainless steel, which is what you want on a boat that may sit in the water all season. The finish matches the rest of our black anodized mounts.

Tighten the clamp evenly so it grips the rail straight, and check it again after the first few trips. Pontoon rails can flex a little, and a clamp that was snug at the dock can ease off after a day of wakes.

Set the clamp where the rail is well supported, close to a post if you can, so the weight of the mount, pole and transducer isn’t hanging off the middle of a long span. Swing the mount through its range before the final tightening to make sure it clears the gate and the furniture.

Wikipedia has a short background on pontoon boats if you’re new to fishing from one. The mounts this clamp supports are under over the side mounts.

Questions

Does the pontoon rail clamp come with the Over the Side Mount?

No. It’s the clamp only. You’ll need an Over the Side Mount or our extra Over the Side Mount base to go with it.

My rail is round. Will it work?

No. It’s for 1 1/4″ square rail. Use the round rail mount for 3/4″ to 1″ round rail.

Can I return it?

Unused, within 30 days. See our returns policy.

Send a photo of your rail and a measurement to sales@trollingmotorsdirect.org, and we’ll confirm the pontoon rail clamp fits before you order.

Related products

error: Content is protected !!