Description
This 1.5 inch MEGA 360 dog bone clamp ties a Humminbird MEGA 360 to a 1.5 inch round shaft or tube. One end has a 1.5 inch bore, the other end holds the 360, and the whole clamp is black powder coated aluminum with stainless steel hardware.
Reading the name
The 1.5-360 in the product name sums it up: 1.5 inches at one end, MEGA 360 at the other. It’s a dog bone, meaning two round clamping ends joined by a web, so it locks two parallel round parts together side by side.
That makes it a fit-by-measurement part rather than a fit-by-motor part. If the thing you’re clamping to measures 1.5 inches across, the 1.5 inch MEGA 360 dog bone clamp is the one to look at. If it doesn’t, one of our other 360 clamps will be the better match.
Measure before you order
- Use calipers if you have them. A tape measure is too coarse for this.
- Measure straight across the diameter where the clamp will sit, not around the outside.
- Check in two or three spots along that section in case the part tapers or has a sleeve on it.
- Note anything nearby, like collars or cable clips, that the clamp has to clear.
A clamp that’s a hair oversized will slip no matter how hard you tighten it, and one that’s undersized won’t close. Getting the number right saves a return trip.
Other 360 clamps we carry
If the 1.5 inch bore isn’t right, look at the LP360 dog bone clamp that pairs with our Low Pro 360 brackets, the clamp for Fortrex, Maxxum and Ghost motors, or the clamp for 2023 and older MotorGuide Tour motors. They’re all in our MEGA 360 mounts section.
1.5 inch MEGA 360 dog bone clamp at a glance
- Ends: 1.5 inch bore and MEGA 360
- Material: aluminum, black powder coat
- Hardware: stainless steel
Once it’s on, keep an eye on the finish. Powder coat holds up well, but a chip from a slipped wrench or a dock bump leaves bare aluminum, and in salt water that spot will start to corrode. A dab of touch-up paint and a freshwater rinse after salt trips keep it looking right for years.
Minn Kota’s 360 Imaging page, where Humminbird’s MEGA 360 is now sold, lists the transducers themselves. Unused non-electronic parts can be returned within 30 days; our returns page explains how.
Questions
Which motors does the 1.5 inch MEGA 360 dog bone clamp fit?
It’s sized by measurement, not by motor: one end fits a 1.5 inch round part. Measure what you’re clamping to, or email us your motor and we’ll tell you which 360 clamp matches.
Does it include hardware?
Yes, stainless steel hardware comes with it.
Send your measurement, trolling motor and 360 model to sales@trollingmotorsdirect.org and we’ll confirm the 1.5 inch bore is right before you order.









